Page 1 of 1

Font

Posted: 05 Jan 2020 17:02
by Chris Mockridge
Hi. Can anyone tell me what Font is used for the "Austin A40" logo on the boot lid of our cars?

Re: Font

Posted: 05 Jan 2020 18:41
by Keith Bennett
Hi Chris, I'm reasonably sure there isn't an actual font one can purchase and I've been through my comprehensive listings of commercially available fonts but can't find a close match. Depending on what words you need to create, perhaps a designer could draw them up from a photo of the "Austin" and "A40" badges seen on the rear bootlids.

I guess you're both busy fettling your A40 for the forthcoming Monte challenge? This year, once again, you should be passing through my home town of Banbury en route for the channel ports and I hope to meet you for a short chat that will appear in FN. Good luck in your endeavours!

Re: Font

Posted: 06 Jan 2020 19:45
by Chris Mockridge
Hello Keith

Thank you for your comments re the font. I'll see if I can find one somewhere near or certainly near enough for what we want.

Sorry to disappoint you or anyone else, but this year we are starting from Reims, I shall miss the lunch halt at Bunbury.

I'll try over the week to write something up to put on here as well as the facebook page.

Regards

Chris

Re: Font

Posted: 06 Jan 2020 20:18
by Dave the rave
Much appreciated you putting it on here Chris. No doubt Keith will include it in FN.

Re: Font

Posted: 07 Jan 2020 14:20
by Keith Bennett
Certainly will, but really sorry to miss you both (and of course Tina the Farina!) and I hope you do find time to send FN an article once the rally is over. The very best of luck to you!